Daikin VRV III REYQ8PY1 Service Manual page 191

Field Setting
Group No. Setting
Example
Indoor/Outdoor Outdoor/Outdoor
F1 F2
Caution When turning the power supply on, the unit may often not accept any operation while "88" is
displaying after all indications were displayed once for about 1 minute on the liquid crystal
display. This is not an operative fault.
3.1.8 Setting of Operation Control Mode from Remote Controller
(Local Setting)
The operation control mode is compatible with a variety of controls and operations by limiting
the functions of the operation remote controller. Furthermore, operations such as remote
controller ON/OFF can be limited in accordance with the combination conditions. (Refer to
information in the next page.)
Central remote controller is normally available for operations. (Except when centralized monitor
is connected)
3.1.9 Contents of Control Modes
Twenty modes consisting of combinations of the following five operation modes with
temperature and operation mode setting by remote controller can be set and displayed by
operation modes 0 through 19.
180
F1 F2
F1 F2 P1 P2 F1 F2 P1 P2
RC
Main
1-00
F1 F2 P1 P2 F1 F2 P1 P2
No Remote Controller
1-03
ON/OFF control impossible by remote controller
Used when you want to turn on/off by central remote controller only.
(Cannot be turned on/off by remote controller.)
OFF control only possible by remote controller
Used when you want to turn on by central remote controller only, and off by remote controller
only.
Centralized
Used when you want to turn on by central remote controller only, and turn on/off freely by
remote controller during set time.
Individual
Used when you want to turn on/off by both central remote controller and remote controller.
Timer operation possible by remote controller
Used when you want to turn on/off by remote controller during set time and you do not want
to start operation by central remote controller when time of system start is programmed.
Indoor/Outdoor Outdoor/Outdoor
F1 F2 F1 F2
F1 F2 P1 P2
RC RC Sub RC
1-02
1-01
F1 F2 P1 P2
RC
1-04
Si37-701
Centoral Remote
Controller
F1 F2
F1 F2 P1 P2
Group Control by Remote Contoller
(autmatic unit address)
F1 F2 P1 P2
(V0917)
Test Operation