Daikin VRV III REYQ8PY1 Service Manual page 190

Si37-701
3.1.7 Centralized Control Group No. Setting
BRC1C Type In order to conduct the central remote control using the central remote controller and the unified
ON/OFF controller, Group No. settings should be made by group using the operating remote
controller.
Make Group No. settings for central remote control using the operating remote controller.
1. While in normal mode, press and hold the "
2. Select the MODE No. "00" with the "
3. Use the "
4. Press "
5. Press "
Note:
NOTICE
Enter the group No. and installation place of the indoor unit into the attached installation table.
Be sure to keep the installation table with the operation manual for maintenance.
BRC7C Type
1. When in the normal mode, push "
BRC7E Type
BRC4C Type
2. Set mode No. "00" with "
3. Set the group No. for each group with "
4. Enter the selected group numbers by pushing "
5. Push "
Test Operation
more to set the system to "Field Setting Mode".
" button to select the group No. for each group.
(Group numbers increase in the order of 1-00, 1-01, ... 1-15, 2-00, ... 4-15.)
" to set the selected group No.
" to return to the NORMAL MODE.
GROUP NO.
For wireless remote controller, see the following.
For setting group No. of HRV and wiring adaptor for other air conditioners, etc., refer to the
instruction manual attached.
Group No. setting by wireless remote controller for centralized control
enters the "field set mode."
" button and return to the normal mode.
" switch for a period of four seconds or
" button.
UNIT NO.
SETTING
TEST
5
" button for 4 seconds or more, and operation then
" button.
" " " button (advance/backward).
" button.
Field Setting
MODE NO.
FIELD SET
MODE
179