Table of Contents
Advertisement
R
ESETTING THE
You can issue a reset for the Campus unit which causes it to complete a soft
reboot. Use this function when one of the following occurs:
•
The Port LED flashes green and the
is displayed when trying to access the REX2 interface. This indicates that
the Campus desktop or line unit is not communicating with the REX2
card for more than 1 minute after power-up was indicated.
•
HDSL, REX2, or system configuration changes have been made, but not
saved, and you want to revert to the previously saved configuration.
•
The REX2 is not functioning properly as indicated by excessive LAN
errors or
During the reset, the Port and HDSL LEDs on the desktop unit flash.
It is not required that you reset the REX2 after a configuration change or
when you complete a save function.
1
From the Main Menu, type
Jul 07, 2003
Local Unit ID:
Remote Unit ID: Inactive
Circuit ID:
ENTER CHOICE>
Campus-REX2 RS Interface Card User Manual
C
AMPUS
Not available
ADC TELECOMMUNICATIONS, CAMPUS RS, Version 5.1 08:19:34
Southall Quad 4
Southeast line 421
1)
SYSTEM STATUS
2)
REX2 CONFIGURATION AND STATUS
3)
SYSTEM CONFIGURATION
4)
MAINTENANCE
5)
REMOTE LOGON
Chapter 5 - Monitoring and Testing the Campus System
U
NIT
REX2 Module Not Read
displayed for configuration values.
4
ENTER
then press
Local I/F:
REX2
Remote I/F: Inactive
MAIN MENU
(L)ogout
y message
.
89
Hide quick links:
Advertisement
Table of Contents
