Table of Contents
Advertisement
Chapter 2 - Configuring HDSL Parameters
Using Standard Mode
Standard mode is the default configuration for the HDSL operating mode.
When standard mode is selected, only three HDSL rates (T1, E1, and 768) are
available. You can select any of the three options for transceiver mode,
however.
1
From the HDSL Parameters menu, type
HDSL Operating Mode is set to Extended. Standard is now displayed as
the HDSL Operating Mode.
It is recommended that you leave the Transceiver Mode
option set to Auto unless you require that a particular end of
the HDSL connection be the Master or Slave.
Also, this value cannot be changed if the HDSL link is up.
2
To change the Transceiver Mode, type
Transceiver Mode changes to the next setting. Repeat until the preferred
setting is selected:
•
Master initiates the HDSL link. The other Campus unit must be set
to Slave or Auto.
•
Slave waits for the other Campus unit to initiate the HDSL link. The
other unit must be set to Master or Auto.
•
Auto (default) automatically switches between Master and Slave
until an HDSL link is established.
The Transceiver Mode option determines the hierarchy of the two
Campus units when attempting to establish an HDSL link.
3
To change the HDSL Rate, type
changes to the next setting. Repeat until the HDSL Rate is set to the
preferred setting of T1 (default), E1, or 768.
S
4
Type
Enter (S)ave to apply changes !
5
To exit the menu, type
Menu).
22
to save and apply HDSL changes as prompted by:
R
(go back one screen) or
1
then press
2
then press
3
ENTER
then press
M
Campus-REX2 RS Interface Card User Manual
ENTER
if the
ENTER
. The
. The HDSL Rate
(return to the Main
Hide quick links:
Advertisement
Table of Contents
