Monitoring Current System Status - ADC Campus-REX2 RS User Manual

Monitoring Current System Status

This screen provides information on the current performance of the
Campus system including both local and remote HDSL alarms and
HDSL performance.
From the System Status Menu, type
System Status screen is displayed.
Jul 07, 2003
Local Unit ID: Southall Quad 4
Remote Unit ID: Central
Circuit ID: Southeast line 421
Local
Remote Alarms:
Loopback: None
Margin (dB):
Pulse Attn (dB):
24 Hour ES:
24 Hour UAS:
Last Cleared:
ENTER CHOICE>
The Current System Status screen provides the following information:
•
Local Alarms indicates the current local alarm status.
•
Remote Alarms indicates the current remote alarm status.
•
Loopback indicates the current loopback status. If no loopback is active,
the status is none.
• Margin indicates the minimum (mn), current (cr), and maximum (mx)
HDSL margin value, measured in dB, relative to the signal-to-noise ratio
required for a Bit Error Rate (BER) of 10
•
Pulse Attenuation (Attn) indicates the decrease in amplitude of the
transmitted signal as measured at the HDSL receiver (in decibels).
•
24 Hour ES indicates the number of errored seconds over the last
24 hours.
•
24 Hour UAS indicates the number of unavailable seconds over the last
24 hours.
•
Last Cleared indicates the date and time when the error counter was last
cleared.
Campus-REX2 RS Interface Card User Manual
ADC TELECOMMUNICATIONS, CAMPUS RS, Version 5.1 08:19:34
CURRENT SYSTEM STATUS
Alarms:
HDSL-A
LOCAL
--------
mn/cr/mx
na/na/na
00
00000
05671
None
(U)pdate
(R)eturn
Chapter 5 - Monitoring and Testing the Campus System
1
then press
Local I/F:
Remote I/F: REX2
REMOTE LOCAL
-------- --------
mn/cr/mx mn/cr/mx
na/na/na na/na/na
00 00
00000 00000
00000 05671
(C)lear
(M)ain Menu
-7
.
ENTER
. The Current
REX2
HDSL-B
REMOTE
--------
mn/cr/mx
na/na/na
00
00000
00000
75