Configuring Spanning Tree Protocol
Complete this section if you want to enable Spanning Tree Protocol (STP).
Spanning Tree Protocol is disabled as a default configuration. See
Spanning Tree Protocol" on page 124
protocol.
1
From the Bridge Configuration screen
ENTER
. The Spanning Tree Configuration screen is displayed.
2
To enable Spanning Tree Protocol, type
also change the Spanning Tree option to Disabled when Enabled is
selected by typing
Jul 07, 2003
Local Unit ID:
Remote Unit ID:
Circuit ID:
UNIT
PORTS
ENTER CHOICE>
Item 10 which allows you to view Spanning Tree Status is available only
when Spanning Tree Protocol is enabled.
3
To set the Bridge Priority, type
enter a value for the bridge priority between 0 and 65535 (default value
is 32768):
Enter New Bridge Priority : 24000
The bridge priority is set relative to other bridges in the same bridged
LAN. The spanning tree priority indicates how centrally located this
bridge is in its network. A lower number indicates a more centrally
located bridge.
Campus-REX2 RS Interface Card User Manual
1
.)
ADC TELECOMMUNICATIONS, CAMPUS RS, Version 5.1 08:19:34
SPANNING TREE CONFIGURATION
1) Spanning Tree Protocol:
2) Bridge Priority:
3) Max Age (sec):
4) Hello Time (sec):
5) Forward Delay (sec):
6) LAN Port Priority:
7) LAN Port Cost:
8) Line Port Priority:
9) Line Port Cost:
10) SPANNING TREE STATUS
(R)eturn
Chapter 3 - Configuring the REX2
for more information about the
(page
3-32), type
1
then press
Local I/F:
Remote I/F: REX2
Enabled
(Disabled, Enabled)
32768
(0 - 65535)
20
(6 - 40)
2
(1 - 10)
15
(2 - 30)
128
(0 - 255)
100
(0 - 65535)
128
(0 - 255)
648
(0 - 65535)
(M)ain Menu
2
then press
ENTER
"About
then press
2
ENTER
. (You can
REX2
. At the prompt,
33