Table of Contents
Advertisement
Configuring RIP
From this screen, you can configure the parameters for Routing Information
Protocol (RIP) to allow the propagation of routing information. Both the Unit
(REX2 card) and Ports (LAN and Line) can be configured. See
Routing" on page 129
1
To configure RIP, from the Router Configuration screen type
ENTER
press
Jul 07, 2003
Local Unit ID:
Remote Unit ID:
Circuit ID:
UNIT
PORTS
ENTER CHOICE>
2
To configure RIP for the Unit (Campus-REX2), do the following:
a
To enable RIP Host Routes, type
enabled, Campus-REX2 accepts host routes in RIP updates.
b
To enable RIP Poison Reverse, type
enabled, this gateway (REX2) indicates to its neighbor gateways
that one of the gateways is no longer connected. It does this by
setting the number of hops to the disconnected gateway to an infinite
number of hops (16, for example).
c
To enable RIP2 authentication, type
uses a plain-text password for authentication that you will set when
you change the RIP2 authentication password.
d
To change the RIP2 authentication password, type
ENTER
up to 16 characters (including alphanumeric or symbols) at the
prompt:
Campus-REX2 RS Interface Card User Manual
for more information about using RIP.
. The RIP Configuration screen is displayed.
ADC TELECOMMUNICATIONS, CAMPUS RS, Version 5.1 08:19:34
RIP CONFIGURATION
1) RIP Host Routes:
2) RIP Poison Reverse:
3) RIP2 Authentication:
4) CHANGE RIP2 PASSWORD
5) LAN RIP Receive:
6) LAN RIP Send:
7) Line RIP Receive:
8) Line RIP Send:
9) DYNAMIC ROUTE TABLE
*Note:
RIP2 Send = send RIP2 multicast messages
RIP1c Send = send RIP2 broadcast messages
(R)eturn
(RIP2 authentication must be enabled). Enter a text string of
Maximum length is 16 characters.
Enter New RIP2 Password : rex2route
Chapter 3 - Configuring the REX2
Local I/F:
Remote I/F: REX2
Enabled
(Disabled, Enabled)
Enabled
(Disabled, Enabled)
Disabled
(Disabled, Enabled)
None
(None, RIP1, RIP2, Both)
None
(None, RIP1, RIP2*, RIP1c*)
None
(None, RIP1, RIP2, Both)
None
(None, RIP1, RIP2*, RIP1c*)
(M)ain Menu
1
then press
2
then press
2
then press
"Dynamic
2
then
REX2
ENTER
. When
ENTER
. When
ENTER
. RIPv2
2
then press
49
Hide quick links:
Advertisement
Table of Contents
