Chapter 2 - Configuring HDSL Parameters
3
To enable the Local Data Port LOS Alarm, type
When enabled, an alarm is generated when a loss of signal is detected at
the data port on the local Campus unit. (To disable this alarm, repeat the
procedure).
4
To enable the Remote Data LOS Alarm, type
When enabled, an alarm is generated when a loss of signal is detected at
the data port on the local Campus unit. (To disable this alarm, repeat the
procedure).
The new HDSL alarm settings take effect immediately after entered and a
save command is not required.
28
8
9
then press
Campus-REX2 RS Interface Card User Manual
ENTER
then press
ENTER
.
.