Configuring Bridge Features - ADC Campus-REX2 RS User Manual

Chapter 3 - Configuring the REX2

Configuring Bridge Features

This section provides procedures for configuring bridging features such as
filter aging and Spanning Tree Protocol. And, although a bridge does not
require an IP address, you will set up IP configuration for the unit so that you
can access it for management using SNMP, telnet, or FTP.
1 To configure the bridge, from the REX2 Configuration and Status screen
type 4 then press
Jul 07, 2003
Local Unit ID:
Remote Unit ID:
Circuit ID:
UNIT IP
ENTER CHOICE>
The bridge and Address Resolution Protocol (ARP) tables are
dynamically built and can be accessed from this screen. See
the Bridge Table" on page 41
for more information.
2 To set the bridge filter age, type
time in seconds from 10 to 100000 (300 is the default) at the prompt:
Enter New Bridge Filter Age in Seconds : 1000
The bridge filter age indicates the time in seconds in which a MAC
address entry is eliminated from the bridging table if it is not relearned.
3 If you want to enable Spanning Tree Protocol, continue to
Spanning Tree Protocol" on page
32
ENTER . The Bridge Configuration screen is displayed.
ADC TELECOMMUNICATIONS, CAMPUS RS, Version 5.1 08:19:34
BRIDGE CONFIGURATION
1) Bridge Filter Age (sec):
2) SPANNING TREE CONFIGURATION
3) BRIDGE TABLE
4) ARP TABLE
5) IP Configuration:
6) IP Address:
Subnet Mask:
7) Default Gateway:
(R)eturn
Local I/F:
Remote I/F: REX2
300 (10 - 100000)
Static (Static, DHCP Client)
192.168. 1. 1
255.255.255. 0
0 .0 .0 .0
(M)ain Menu
and "Viewing the ARP Table" on page 42
1 then press ENTER
33.
Campus-REX2 RS Interface Card User Manual
REX2
"Viewing
. Enter the filter age
"Configuring