Table of Contents
Advertisement
d
To select the version of RIP packets that will be sent by the Line
port, type
version is selected:
•
•
•
•
4
To view the routing table that is dynamically created by RIP, type
press
ENTER
page
3-59).
5
Type
R
(page
3-46). (Typing
6
If you are only changing RIP configuration parameters, go to
Router Configuration" on page 55
Configuring and Deleting Static IP Routes
Static IP routes define a fixed and manually configured path for data sent by
the Campus-REX2 to a destination host. This table contains a maximum of
32 explicit routes. Each route comprises a destination network, subnet mask,
and hop count.
You can add static routes by selecting either:
•
Add Static Route as described in this section
•
Static Route Table (see
page
57) and using the (A)dd route command
When you enter a static IP address that is a specific host interface, you must
enter 255.255.255.255 as the subnet mask to include that specific host
interface in the static routing table.
You can also configure the default gateway in the static routing table by
entering a destination IP address of 0.0.0.0 with a subnet mask of 0.0.0.0 and
then entering the IP address for the default gateway.
Campus-REX2 RS Interface Card User Manual
8
then press
None indicates that a RIP version is not selected.
RIP1 indicates that only RIPv1 packets will be sent by the LAN
port.
RIP2 indicates that RIPv2 multicast packets will be sent by the
LAN port.
RIPC indicates the RIPv2 broadcast messages will be sent by
the LAN port.
. For information about the Dynamic Route Table, go to
then press
ENTER
M
will return you to the Main Menu.)
"Managing the Static Routing Table" on
Chapter 3 - Configuring the REX2
ENTER
. Repeat until the preferred RIP
to return to the Router Configuration screen
to save your changes.
then
9
"Saving the
51
Hide quick links:
Advertisement
Table of Contents
