Powering Up And Checking The Connection - ADC Campus-REX2 RS User Manual

P
OWERING
Verify operating status after completing a full installation that includes
installing of the Campus-REX2 into a desktop unit or Campus-Star chassis
and then completing the installation of the desktop unit or the Campus-Star
chassis (including the Line Unit):
1 Verify that the power cord is connected to the desktop unit or to the
Campus-Star chassis (if you have an AC power supply) and to an
external power source. Then verify the powerup of and HDSL
connection for that unit as specified in the appropriate user manual.
2 If the Campus-REX2 is installed in a desktop unit, press the power button
to On. The button is located on the back of the desktop unit.
3 Verify that the Link LED on the Campus-REX2 card is green. This
indicates that the 10/100Base-T connection is operating correctly. If the
Link LED does not light green, check the 10/100Base-T cabling
configuration.
If the link LED does not light green, check that the MDI/MDI-X switch
is set to the appropriate position.
Campus-REX2 RS Interface Card User Manual
U C
P AND HECKING THE
Chapter 1 - Installing and Accessing the REX2
C
ONNECTION
7