Table of Contents
Advertisement
Chapter 3 - Configuring the REX2
3
To configure RIP for the LAN and Line ports, do the following:
a
To select the version of RIP packets that will be received by the
LAN port, type
version is selected:
•
•
•
•
b
To select the version of RIP packets that will be sent by the LAN
port, type
version is selected:
•
•
•
•
c
To select the version of RIP packets that will be received by the Line
port, type
version is selected:
•
•
•
•
50
5
then press
None indicates that a RIP version is not selected.
RIP1 indicates that only RIPv1 packets will be received by the
LAN port.
RIP2 indicates that only RIPv2 packets will be received by the
LAN port.
Both indicates that both RIPv1 and RIPv2 packets will be
received by the LAN port.
6
then press
None indicates that a RIP version is not selected.
RIP1 indicates that only RIPv1 packets will be sent by the LAN
port.
RIP2 indicates that RIPv2 multicast packets will be sent by the
LAN port.
RIP1c indicates the RIPv2 broadcast messages will be sent by
the LAN port.
7
then press
None indicates that a RIP version is not selected.
RIP1 indicates that only RIPv1 packets will be received by the
Line port.
RIP2 indicates that only RIPv2 packets will be received by the
Line port.
Both indicates that both RIPv1 and RIPv2 packets will be
received by the Line port.
ENTER
. Repeat until the preferred RIP
ENTER
. Repeat until the preferred RIP
ENTER
. Repeat until the preferred RIP
Campus-REX2 RS Interface Card User Manual
Hide quick links:
Advertisement
Table of Contents
