ADC Campus-REX2 RS User Manual page 69

Managing the Static Routing Table
The entries in this routing table were configured by a user (entered statically).
This table contains a maximum of 32 entries. You can manage entries or you
can also add new entries from this screen. The destination shown on this
screen is for a host route, but not for a specific host device.
You can also configure the default gateway in the static routing table by
entering a destination IP address of 0.0.0.0 with a subnet mask of 0.0.0.0 and
then entering the IP address for the default gateway (see
The Static Route Table can be accessed from both the Router Configuration
and the Static Route Configuration screens.
1 Do one of the following to access the Static Route Table:
•
From the Router Configuration screen, type
•
From the Static Route Configuration screen, type
ENTER
TABLE>
Campus-REX2 RS Interface Card User Manual
. The Static Route Table is displayed.
STATIC ROUTE TABLE
DESTINATION SUBNET MASK
192.128.128. 60 255.255.255.252
168.120.100. 12 255.255.255.252
172.100.200. 25 255.255.255.255
(P)revious (N)ext
(C)lear table (A)dd route
(R)eturn
Chapter 3 - Configuring the REX2
GATEWAY ADDRESS
192.150. 10. 50
192.150. 10. 50
192.150. 10. 50
(F)ind (E)ntire table
(D)elete route
(M)ain Menu
page 3-48).
5 ENTER
then press
then press
3
HOP
1
1
1
.
57