Upgfrm - Broadcom NetXtreme BCM570 Series Diagnostic User Manual

Broadcom NetXtreme Ethernet Adapter • Diagnostic User's Guide
a. Wol_enable
b. Wol_Limit_10
c. Driver_wol_enable
d. Lom_design
e. Phy_auto_power_down
f. Reverse_nway
g. Disable_power_saving
h. Phy_led_mode
i. Shasta_ext_led_mode
j. Cable_sense

10.9 upgfrm

cmd: upgfrm
Description: Upgrade ISCSI, PXE, Boot Code and Selfboot Firmware from a File. This
command reads code from a file and program into iscsi, pxe or boot area. Both parameter,
the programming target '-p', 'b' or '-i' and filename, must be specified. In case of ISCSI
firmware, ISCSI Boot Firmware will be updated by default. ISCSI CFG Block will only be
updated if there is no ISCSI CFG Block present in NVRAM. ISCSI CFG Program will
NOT be programmed by this command. In case of Selfboot Firmware, this command will
support Format 0 to Format 1 and Format1 to Format1 update. Format0 to Format0 and
Format1 to Format0 update are NOT supported by this command. User will need to use
"seprg" command.
Syntax: upgfrm <p | b | i> filename
upgfrm [-f<filename>] [-b | -p | -i] | [-d]
Options:
-b
-d
-f<string>
-p
Upgrade boot code/Selfboot firmware
Do not perform device check
Input file
Upgrade PXE code
page 60
Broadcom Confidential and Proprietary