Broadcom NetXtreme BCM570 Series Diagnostic User Manual page 151

Broadcom NetXtreme Ethernet Adapter • Diagnostic User's Guide
/* ERR_CPU_MEM2
%08X",
/* ERR_SERIAL1
/* ERR_SERIAL2
/* ERR_POWER1
/* ERR_POWER2
/* ERR_UMP_VS_DEV
/* ERR_HM_BR_LANES
linked and running, expected %d.",
/* ERR_BRIDGE
/* ERR_NO_LINK10
/* ERR_NO_LINK100
/* ERR_NO_LINK1000
/* ERR_DMA_SHASTA
/* ERR_SECFG_CONT
/* ERR_SECFG_INVALID
/* ERR_NV_SELFBOOT
/* ERR_PART_NUM
/* ERR_UMPECHO
/* ERR_IMAGE_CHECKSUM
/* ERR_INVALID_SMB
/* ERR_LOM_CFG
/* ERR_ISCSI_PGM
/* ERR_BAD_CHIP_REV
/* ERR_NO_CPU
/* ERR_BAD_PARITY_VALUE
/* ERR_BAD_VPD_CHKSUM
/* ERR_ESWITCH_CTRL_TO
/* ERR_ESWITCH_EVENT
/* ERR_ESWITCH_TO
/* ERR_ESWITCH_ARBIT_TO
/* ERR_ESWITCH_INTR
/* ERR_ESWITCH_STATUS
164 */ "%s CPU memory error @ %08X, expected %08X but got
165 */ "PCIE Serial Device Number Capability Not Found.",
166 */ "PCIE Serial Device Number Match Failure.",
167 */ "PCIE Power Budget Capability Not Found.",
168 */ "PCIE Power Budget Error (ad=%d, saw=%x, exp=%x).",
169 */ "UMP VS Device Error",
170 */"HM Bridge Lanes Error: %d PCI-E lanes are actually
171 */ "Invalid bridge.",
172 */ "No good link at 10 Mbits/s! Check Loopback plug",
173 */ "No good link at 100 Mbits/s! Check Loopback plug",
174 */ "No good link at 1000 Mbits/s! Check Loopback plug",
175 */ "\nFailed! Saw=%x @ %x, Exp=%x from %x\n",
176 */ "SECFG Config Error. Line %d",
177 */ "Invalid Argument in SECFG Config File at Line %d",
178 */ "NVRAM is SELFBOOT",
179 */ "Error Part Number Chick Failed"
180 */ "UMP Echo - Debug Mode",
181 */ "Firmware image checksum error",
182 */ "Invalid SMB Address",
183 */ "LOM CONF Bit mismatch in Reg 178 and Reg 7C04",
184 */ "iSCSI Programming Error",
185 */ "Invalid Chip Rev.",
186 */ "Device has no internal CPU",
187 */ "Invalid Parity.",
188 */ "Invalid VPD Checksum",
189 */ "Halting E Switch Ctrl time out. %x",
190 */ "ESWITCH event not set. %x",
191 */ "E Switch time out. %x",
192 */ "Halting E Switch Ctrl Arbitor time out. %x",
193 */ "ESWITCH interrupt not set. %d",
194 */ "ESWITCH status word not set. %x"
page 142
Broadcom Confidential and Proprietary