Routing Cables; Top Cabling - Huawei UPS5000-S-880 kVA User Manual

UPS5000-S-880 kVA
User Manual (CMI)
Figure 3-22 Preparing a cable terminal outside the cabinet
Step 4 Connect the cable with a crimped terminal to the corresponding copper bar.
Step 5 Clean foreign matter inside the cabinet.
----End

3.2.5 Routing Cables




3.2.5.1 Top Cabling

Context


Issue 02 (2020-01-10)
Choose an appropriate cabling route based on the actual situation. The figure is for reference only.
This section describes cable connections when the mains input and bypass input use
different power sources. When they use the same power source, there is no need to remove
the copper bars between the mains and bypass input terminals or connect the bypass input
power cable.
Determine the cable cross-sectional area and quantity based on the section "Preparing
Power Cables" and site requirements. The figures are for reference only.
Route cables for the UPS from inside out and from top down.
This section describes cable connections when the mains input and bypass input use
different power sources. When they use the same power source, you do not need to remove
the copper bars between the mains and bypass input terminals or connect the bypass input
power cable.
Copyright © Huawei Technologies Co., Ltd.
3 Installation
67