Huawei UPS5000-S-880 kVA User Manual page 141

UPS5000-S-880 kVA
User Manual (CMI)

Single batt. float chg. voltage deviation alarm thres. and Single batt. dis. voltage
deviation alarm thres. are used to check whether the batteries in each battery string have
the same charge voltage and discharge voltage. When a value exceeds the specified range,
an alarm is generated. The calculation formula is (Charge/Discharge voltage – Average
voltage)/Average voltage x 100%. The charge/discharge voltage and average voltage are
obtained from the BMU. If the BMU is not configured, these two parameters do not need
to be set.
Item
Float volt.
temp. comp.
Float volt.
temp. comp.
coef.
(mV/° C· cell)
Float Chg temp
comp center
(° C)
Automatic
equalized
charging
Transfer-to-
equalized
charging cur.
coef. (C10)
SOC to start
equalized
charging (%)
Scheduled
equalized
charging
interval (d)
Equalized
charging
protection
interval (d)
Issue 02 (2020-01-10)
Description
If this parameter is set to Enable,
the float voltage is calibrated
based on the battery temperature
when a battery temperature
sensor is connected. The
parameter is configurable in any
mode.
Calibration coefficient during
float voltage temperature
compensation.
Indicates the reference
temperature during temperature
compensation of the float
charging voltage.
If this parameter is set to Enable,
the UPS automatically changes
the battery management status to
equalized charge based on the
charge current and float charge
time.
The battery enters equalized
charge state when the battery
current exceeds this parameter
value.
If the SOC is lower than the
specified value, batteries start
equalized charging.
After batteries transfer from
equalized charging to float
charging, if the batteries do not
discharge, equalized charging
starts only after the float charging
time reaches Equalized
charging protection interval.
After equalized charging is
complete, scheduled equalized
charging starts when the non-
equalized charging time exceeds
Scheduled equalized charging
Copyright © Huawei Technologies Co., Ltd.
4 User Interface
Default Value Value Range
Enable Disable, Enable
3.3 0.0–6.0
25 20–30
Enable Disable, Enable
0.05 0.02–0.08
70 0–100
60 30–180
7 0–15
133