Huawei UPS5000-S-880 kVA User Manual page 138

UPS5000-S-880 kVA
User Manual (CMI)
Input Settings
Output Settings
Issue 02 (2020-01-10)
Item Description
time site one waveform can be stored
waveform manually.
BCB trips in If this parameter is set to Enable,
case of EOD
the BCB will trip in case of
EOD.
Item Description
Input The value of Input adaptability
adaptability can be Strong or Weak. Strong
input adaptability applies to the
D.G. or input sources whose
input current has high frequency
oscillation. In this mode, the total
distortion of the input current
waveform (THDi) is poor, but
the system is stable. Weak input
adaptability is suitable for mains
and AC input sources.
Item Description
Zero display If this parameter is set to Enable,
with no load the output current is displayed as
output 0 when no load is output. The
output load rate is displayed as
3%. When this parameter is set to
Disabled, the output current and
output load rate are not adjusted
to zero.
Calib. output If this parameter is set to Enable,
current if no the current at no load will be
load calibrated once automatically.
This function can be used only
when the UPS carries no load.
Output Set this parameter based on the
interruption output interruption time
acceptable to loads.
transfer time
(ms)
Max. BPM Cross currents occur during the
transfer times transfer between bypass mode
and normal mode, which impacts
Copyright © Huawei Technologies Co., Ltd.
4 User Interface
Default Value Value Range
Enable Disable, Enable
Default Value Value Range
Strong Strong, Weak
Default Value Value Range
Enable Disable, Enable
Disable Disable, Enable
0 0 ms, 40 ms, 60
ms, 80 ms, 100
ms, 120 ms
5 1–10
130