JUKI LH-4500C Series Instruction Manual page 162

❾
❽
<Condensation custom pattern list screen>
2. In the case of setting the stitch length
Possible input range is same as that of "S003 Stitch length".
Set the stitch length for step 1 to 1.0 mm using numeric keypad  and
 to confirm the setting.
Press
A negative number of stitches can also be set. In this case, the direction of feed is reverse direction.
3. Carry out the following setting in the similar manner.
The number of stitches for step 2: 4 stitches
Stitch length for step 2: 1.5 mm
The number of stitches for step 3: 3 stitches
Stitch length for step 3: 1.0 mm
The number of stitches for step 4: 3 stitches
Stitch length for step 4: -1.0 mm
The number of stitches for step 5: 2 stitches
Stitch length for step 5: 1.5 mm
⑤ Confirming the numeric value
<Condensation custom edit screen>
<Condensation custom pattern list screen>




1. In the case of setting the number of
stitches
Condensation custom pattern input
procedure is described as follows using
< Figure: Example of the condensation
custom pattern > as an example.
The number of stitches can be input in
the range from 1 to 100.
Set the number of stitches for step 1 to 3
with numeric keypad ❽
Press
Press
The condensation custom list screen is
displayed with the condensation custom
number you have created added.
– 157 –
 to confirm the setting.
 .
 to confirm the setting.
❾ .