JUKI LH-4500C Series Instruction Manual page 139

② Editing the number of stitches of polygonal shape stitching and the step changeover
condition to be satisfied by a new step
❷
<Polygonal-shape stitching step edit screen>
❺
<Sewing data edit screen>
❻
<Step changeover reference selection screen>
* In the case of the "separately driven needle bar changeover", the sewing machine automatically
stops when the set number of stitches have been sewn. However, the step does not proceed.
The step proceeds to the next step when you operate the separately driven needle bar changeover
lever to change over to the separately driven needle bar operation mode.
In the case the sewing machine re-starts sewing after automatic stop, it carries out free stitching
operation.
❼ is pressed, the operation is confirmed. Then, the screen returns to the "sewing data
4) When
edit screen".
❸
❹
❼
– 134 –
1) Step changeover condition is displayed
in ❷ . Press ❷ to place the number of
stitches in the selected state.
The screen returns to the previous one
or advances to the next one with
❸ .
2) When the selected step is pressed
again, the "sewing data edit screen" is
displayed.
❹ is pressed, the "sewing
When
data edit screen" for the next step is
displayed.
❺ is pressed, the "step
When
changeover reference selection screen"
is displayed.
3) Selecting step changeover reference
❻ .
: Number of stitches
: One-touch changeover
: Multi-layered section detection
: Separately-driven needle bar
changeover