JUKI LH-4500C Series Instruction Manual page 155

④ Creating a custom pattern
A B
❻
Stitch length
Number of stitches
<Custom pattern edit screen>
❽
❾
<Custom pattern data input screen>
2. In the case of setting the stitch length
Possible input range is same as that of "S003 Stitch length".
Set the stitch length for step 1 to 1.0 mm using numeric keypad  and
 to confirm the setting.
Press
3. Carry out the following setting in the similar manner.
The number of stitches for step 2: 2 stitches
Stitch length for step 2: 2.0 mm
The number of stitches for step 3: 1 stitch
Stitch length for step 3: 3.0 mm
The number of stitches for step 4: 2 stitches
Stitch length for step 4: 1.5 mm
❻ ❼



When ❻ is pressed, the pressed step
1)
is in the selected state.
2) Selected custom pattern number is
displayed in A, and the step number
that is being edited and the number of
all steps are displayed in B.
3) The "number of stitches" and "stitch
length" of the step are displayed in ❻ .
When ❻ is pressed, it is in the selected
state. Previous pattern number screen
or next pattern number screen will be
displayed by pressing
When ❻ is pressed while the step is in
4)
the selected state, the "Custom pattern
data input screen" is displayed.
1. In the case of setting the number of
stitches
In this paragraph, an example of entry of a
custom pattern shown in < Figure: Example
of custom pattern > as an example.
The number of stitches can be input in
the range of 1 and 100.
Set the number of stitches for step 1 to
3 with numeric keypad ❽ for the num-
ber of stitches and
Press
– 150 –
❼ .
❾ .
 to confirm the setting.
 .