JUKI LH-4500C Series Instruction Manual page 142


B C
<Teaching input screen (In the case the step changeover
basis is the detection of a multi-layered portion of material)>

<Teaching input screen (In the case the step changeover
basis is one-touch type changeover)>
<Sewing data edit screen>


– 137 –
Or, in the case the step changeover
basis is the detection of a multi-layered
portion of material, the multi-layered
portion detection sensor value B is
entered to the step changeover sensor
value C by pressing  .
Change other sewing conditions with
 .
・
: Stitch length
・
: Presser foot pressure
・
: Needle thread tension (left)
・
: Needle thread tension (right)
 is pressed, the step is
When
changed over to the next one.
Confirm the teaching data you have en-
tered by carrying out thread trimming.
Then, the screen returns to the "Sew-
ing data edit screen" which reflects the
sewing condition you have changed.
8) In the case additional registration of a
step to the sewing pattern is possible,
step  that is not yet set will be dis-
played at the rightmost field.