Table of Contents
Advertisement
Safety Instructions
3 Safety Instructions
3.1 Symbols used in this Manual
3
3
The following symbols are used in this document.
WARNING
Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury. It may
also be used to alert against unsafe practices.
CAUTION
Indicates a situation that may result in equipment or
property-damage-only accidents.
NOTE
Indicates highlighted information that should be regarded
with attention to avoid mistakes or operate equipment at
less than optimal performance.
3.2 General
The following safety instructions and precautions are
primarily related to using ISD 410 servomotors in an
ISD 410 servo system. The number of servomotors in the
servo system is not significant for this.
Read the safety instructions carefully before starting to
work in any way with the servomotors.
When working with the servomotors, pay particular
attention to the safety instructions in the relevant sections
of this instruction manual.
Also observe the safety instructions and precautions in the
instruction manuals for the other system components.
8
®
VLT
ISD 410 Servomotor Operating Instructions
HIGH VOLTAGE
ISD 410 servomotors operate at a high voltage when
connected to the electrical supply network.
A hazardous voltage is present on the servomotors
whenever they are connected to the mains network via the
power supply module and the connection box.
There are no indicators on the servomotor that indicate
the presence of mains voltage. This indication is provided
at the distributor box. Installation, commissioning and
maintenance may only be performed by qualified staff.
Incorrect installation, commissioning or maintenance can
lead to death or serious injury.
HAZARDOUS SITUATION
If the servomotor or the bus lines is/are incorrectly
connected, there is a risk of damage to the equipment or
personal injury, which may even prove fatal. For this
reason, always comply with the instructions in this manual,
as well as national and local safety regulations. Read the
operating instructions for the other components of the ISD
410 servo system.
3.3 Safety Instructions and Precautions
Read the safety instructions carefully before starting to
work in any way with the servomotors. Compliance with
the safety instructions and precautions is necessary at all
times.
•
•
•
•
•
•
®
MG75D102 - VLT
is a registered Danfoss trademark
WARNING
WARNING
Orderly and proper transport, storage, fitting and
installation, as well as careful operation and
maintenance, are essential for the trouble-free
and safe operation of this equipment.
Only suitably trained and qualified staff may work
on the equipment or in its vicinity. See
3.4 Qualified Personnel.
Use only accessories and spare parts approved by
the manufacturer.
Comply with the specified ambient conditions.
The information in these operating instructions
about the use of available components is
provided solely by way of examples of
applications and suggestions.
The plant engineer or system engineer is
personally responsible for checking the suitability
of the supplied components and the information
Advertisement
Table of Contents
