Table of Contents
Advertisement
Mounting and Removing
Your Fiber Blocks
Chapter Summary
You can horizontally or vertically mount SynchLink blocks on a
standard 35mm DIN rail.
· To install the blocks, snap them on the DIN rail by hand.
· To remove components from the DIN rail, use a flat-blade
screwdriver.
An example of the DIN-rail mounted SynchLink hub is shown in
Figure 7.2.
When properly installed, SynchLink blocks are
ATTENTION
grounded through the DIN rail to chassis ground.
Use zinc-plated, yellow-chromated steel DIN rail to
!
assure proper grounding. Using other DIN rail
materials (e.g. aluminum, plastic, etc.) which can
corrode, oxidize, or are poor conductors can result
in improper or intermittent platform grounding.
Mount blocks only on zinc-plated, yellow-chromated
steel DIN rail. Refer to the blocks' installation
instructions for more information.
Figure 7.2 DIN-Rail Mounted SynchLink Hub
In this chapter, you read about installing a SynchLink fiber optic
cable system.
Chapter 8 offers Guidelines for SynchLink Fiber Optic Cable
Installation.
DIN Rail
A-B part no. 199-DR1
DIN 46277-3
EN 50022 (35 x 7.5mm)
31205-M
Publication 1756-TD008A-EN-P - August 2002
7-5
Advertisement
Table of Contents
