Chapter Summary
Powering your System
To power your SynchLink fiber optic cable system:
1. Connect cables to nodes, hubs, or bypass switches in
accordance with your cable layout.
2. Power hubs and bypass switches in accordance with instructions
provided in their installation instructions.
Be certain that all blocks are attached and secured
IMPORTANT
prior to applying power to them. Failure to do so
may cause damage to the blocks.
Be certain to properly ground the DIN rails. Refer to
the instructions provided with the DIN rails.
In this chapter, you read about an overview of the SynchLink Fiber
Optic cable system.
Chapter 6 explains Planning a SynchLink Fiber Optic Cable System.
Publication 1756-TD008A-EN-P - August 2002
5-5