Table of Contents
Advertisement
3-10
Publication 1756-TD008A-EN-P - August 2002
Fiber Optic Cables
The SynchLink fiber optic cable assemblies are manufactured from
200/230 micron/simplex cable with a Versalink (V-Link) V-pin
connectors at the ends. For a list of cable assembly specifications, see
Table 3.2. For a complete list of SynchLink fiber optic cable system
products, see Table 7.1 on page 7-2.
· Never look into a transmitter's output or the end
ATTENTION
!
· Do not look directly into the fiber ports. Light
· Never use a microscope to view an active cable
Table 3.2
Fiber Optic Cable Assemblies Specifications
Cable Segment Length
Cable Splicing
Operating Wavelength
Cable Attenuation
(1)
The maximum cable length is calculated differently, depending on topology. For more information, see
page 7-4.
For a full description of how to plan, install and troubleshoot a
SynchLink system, including connecting these products, see Chapter 5
through Chapter 9.
of a cable with an active transmitter connected.
levels may cause damage to your eyesight.
system. The concentration of light from the
microscope could cause permanent damage to
your eye. SynchLink products are Class 1 LED
products.
300m maximum
1m minimum
Not permitted
650nm (red) nominal
12 dB/km maximum at 650nm
(1)
Advertisement
Table of Contents
