Ipmi - SMART Embedded Computing ATCA-F140 Series Installation And Use Manual

Functional Description
4.4

IPMI

The IPMI function of the ATCA-F140 is implemented using the SMART Embedded
Computing common ATCA base IPMI design. This building block is based on the Pigeon
Point Systems IPMI implementation using the Renesas HD64F2166 microcontroller which
is part of the H8S controller family. The IPMI building block implementation provides the
following features:
 Two IPMB interfaces to the backplane
 One local IPMB interface for on-board IPMI
 One I
 One private I
 Serial UART (SIPL) and KCS/LPC interfaces to the P2020 service processor
 Analog voltage sensor inputs
 Service processor boot flash fall over selection
 Watch-dog timer

Hot swap control
 Temperature sensors
94
2
C/IPMB interface for intelligent or non-intelligent RTMs
2
C interface for non-intelligent I
2
C devices
ATCA-F140 Series Installation and Use (6806800M67S)
Functional Description