Table of Contents
Advertisement
2. Wait until the blue LED is illuminated permanently. Unfasten the screws of the face
plate, then unlatch the handle and pull the handle fully outward until the blade is
detached from the shelf.
If the LED continues to blink, it is possible that the upper layer software has rejected
the blade extraction request.
3. Remove the face plate cables, if applicable.
4. Remove the blade from the shelf.
ATCA-F140 Series Installation and Use (6806800M67S)
Hardware Preparation and Installation
57
Advertisement
Table of Contents
Need help?
Do you have a question about the ATCA-F140 Series and is the answer not in the manual?