5) Installing pneumatic parts
A. Fix the filter regulator① to the rear side of the table leg
using the bolt② and the nut③.
B. Fix the solenoid valve④ at a proper place below the
table and fix it with the fixing
C. Connect air hoses of the machine to the solenoid valve.
1 Upper trimmer(back)
2 Upper thread release
3 Lower thread adjuster
4 Fabric open(left)
5 Fabric open(right)
6 Presser bar(left)
7 Presser bar(right)
8 Upper thread hol d er base support(back) 18 Thread securing device(back)
9 Upper thread hol d er base suppor(front) 19 Thread securing device(front)
10 Upper thread holder(back)
16
screw⑤.
11 Upper thread holder(front)
12 Thread holder
13 Cutter(front)
14 Cutter(back)
15 Y-union
16 Lower trimmer
17 Lower trimmer(front)
② ①
③
⒃
⒔
⑤
⑧
④
⑩
⑨
⑦
⑪
⑫
⒕
⑥
⒖
·00 type is excluded ⒕ ,⒖ the thread securing device
and ⒃, ⒔ the lower trimmers and ⑧, ⑨, ⑩, ⑪, ⑫
related with the upper thread holder.
·In the 02 type model, the thread securing devices ⒕,
⒖ are not included.
③
⑤
②
①
④
⑬
⑭
⑮
[ Fig. 6 ]
[ Fig. 7 ]