Adjusting The Fabric Opening; Adjusting The Pneumatic Pressure - SunStar SPS/E-BH6100-00 User Manual

21) Adjusting the fabric opening

A. The fabric opening should be 1.4mm composed of 0.7mm
of the left plate opening① and 0.7mm of the right plate
opening② respectively.
B. Loosen the tightening screw③ for the fabric opening
cylinder and set the distance between the left cover plate①
and the right cover plate② at 3.6mm.
C. During the operation of the fabric opening cylinder, adjust
the cover plate cushion position to set the distance between
cover plates at 5.0mm. In this case, the opening of the left
and right cover plates should be same.

22) Adjusting the pneumatic pressure

A. As in the figure, pull down the adjusting knobs① at the
bottom of the filter regulator attached under the table and
turn them to the right. Then pressure increases. When they
are turned to the other side, pressure decreases. When
pressure indicated on the pressure gauge is properly
adjusted, place the adjusting knobs① back to their original
position and fix them.
B. The proper pressure of the main adjuster② sis 0.5MPa, and
that of the cutter adjuster③ is 0.3MPa.
40
①
before sewing:
3.6mm
after sewing:
5.0mm
②
②
③
[ Fig. 57 ]
③
①
[ Fig. 58 ]