Attach Needles - SunStar SPS/E-BH6100-00 User Manual

D. Put oil near looper base (everyday)
ⓐ Remove the cloth press plate ①.
ⓑ Lift the body of the machine.
ⓒ Drop oil to the spreader operating cam②, the looper operating link③, and the spreader cam link④
ⓓ Put several drops of oil to the left ⑤ & right spreader ⑥ axles, and the LS Holder Bracket⑦
ⓔ Properly supply oil to the felt presser bar⑧.

2) Attach needles

A. Lift the finger guard①.
B. Turn the hand pulley to move the needle bar to the highest position.
C. Disassemble the fabric presser bar and check if the looper base hole② is aligned with the bed hole.
D. Loosen the fixing screw④ for the needle bar③, and with the long groove of the needle headed forward, push the needle
into the needle bar entrance until the tip of the needle top reaches the end. Then fix the needle with the needle fixing
screw④.
E. Lower the finger guard①.
[ CAUTION ]
Needle used: DO×579 Nm90~125
①
①
②
⑦
③
⑧
②
⑥
⑤
④
[ Fig. 17 ]
④
③
[ Fig. 18 ]
21