Table of Contents
Advertisement
OPERATION
4
Screen
43
Steps
•
[ ] or [ ] for the selection of the
measurement name (Distance, Level,
Conversion, Ullage Conv. or Reflection).
•
[^ ^ ^ ^ ] to confirm.
•
[ ] or [ ] for the selection of the current
output range (4-20 mA/3.6E, 4-20, 3.8-
20.5/3.6E, etc.).
•
[^ ^ ^ ^ ] to confirm.
•
[> > > > ] to change Scale 4 mA.
•
[> > > > ] to change the position of the cursor.
•
[ ] to decrease the value or [ ] to
increase the value.
•
[^ ^ ^ ^ ] to confirm.
•
[> > > > ] to change Scale 20 mA.
•
[> > > > ] to change the position of the cursor.
•
[ ] to decrease the value or [ ] to
increase the value.
•
[^ ^ ^ ^ ] to confirm.
•
[ ] or [ ] for the selection of the error
delay (0 s, 10 s, 20 s, 30 s, 1 mn, 2 mn,
5 mn or 15 mn).
•
[^ ^ ^ ^ ] to confirm.
www.drexelbrook.com
Description
The manufacturer sets the output function
to "Level" before delivery.
If it is necessary to measure volume, ullage
volume, mass or ullage mass (Conversion
or Ullage Conv.), refer to the handbook.
Use this step to give the 4 mA output setting
(0% limit) in the tank. Refer to the
illustrations that follow. Illustration 1
shows the settings for level. Illustration 2
shows the settings for distance.
Use this step to give the 20 mA output
setting (100% limit) in the tank. Refer to the
illustrations that follow. Illustration 1
shows the settings for level. Illustration 2
shows the settings for distance.
The time after which the current output
changes to an error value. The error value
shows that there is a measurement error.
DR5200QS-LM, EDO#6-13-112 - Issue #3
DR5200
Advertisement
Table of Contents
