Table of Contents
Advertisement
INSTALLATION
2
2.8.5 Wall support for the remote version
Figure 2-31: Wall support for the remote version (attached to the remote converter)
1 Use marks on the wall to help you put the wall support in the correct position. For more data,
refer to "Dimensions and Weights" in the handbook.
2 Use equipment and tools that agree with health and safety regulations and good engineering
practice.
3 Make sure that the wall support is correctly attached to the wall.
2.8.6 How to attach an antenna extension (Metallic Horn or Wave Guide antennas)
CAUTION!
IF THE ANTENNA EXTENSION IS SUPPLIED WITH THE DEVICE AS AN OPTION:
If the antenna extension is attached to the device, no more work is necessary.
If the antenna extension is not attached to the device, refer to Procedure 1 in this section. It is not
necessary to change the device settings. The manufacturer sets the related menu items to the
correct values in the factory.
IF THE ANTENNA EXTENSION IS SUPPLIED AFTER DELIVERY OF THE DEVICE (SPARE PART):
You must attach the antenna extension to the device and change the device settings in the
SUPERVISOR menu. If you have a straight antenna extension, refer to Procedures 1 and 2A. If you
have an S-bend or L-bend (right-angle) antenna extension, refer to Procedures 1 and 2B.
DANGER!
If you installed the device on the tank before the procedure, make the device safe (de-energize
the circuit, clean the device etc.) before you continue the work.
23
www.drexelbrook.com
DR5200
DR5200QS-LM, EDO#6-13-112 - Issue #3
Advertisement
Table of Contents
