How To Assemble The Ptfe Wave Horn Antenna - Ametek DR5200 Quick Start Manual

Radar (fmcw) level transmitter for liquids in storage and process applications

Hide thumbs Also See for DR5200:

Table of Contents

INSTALLATION

2.5 How to assemble the PTFE Wave Horn antenna

Figure 2-5: Equipment needed to assemble the device

1 Signal converter and process connection (compact version) or antenna housing and process connection (remote ver-

sion)

2 PTFE Wave Horn antenna in cardboard packaging. The cardboard packaging is attached with 4 screws and wingnuts.

Part 1: Remove the protective cover from the process connection

Figure 2-6: Part 1: Remove the protective cover from the process connection

• Remove the plastic cover from the process connection.

Part2: Remove the cardboard packaging from the PTFE Wave Horn antenna

Figure 2-7: Part2: Remove the cardboard packaging from the PTFE Wave Horn antenna

• Remove the 4 wingnuts and screws that attach cardboard packaging.

• Remove the top and the bottom of the cardboard packaging from the PTFE Wave Horn

antenna.

Part3A: Attach the PTFE Wave Horn antenna to the process connection

Figure 2-8: Part3A: Attach the PTFE Wave Horn antenna to the process connection

CAUTION!

Do not use tools to attach the antenna to the process connection.

• Attach the Wave Horn antenna to the process connection. Put the end of the antenna that has

a thread in the fitting on the process connection.

www.drexelbrook.com

DR5200

DR5200QS-LM, EDO#6-13-112 - Issue #3

Table of Contents