Table of Contents
Advertisement
DR5200
Figure 2-37: Installation of the weather protection on a horizontal signal converter
INFORMATION!
Install the weather protection after you connect the device to the power supply.
1 Put the weather protection clamp around the front of the device (the end of the device that is
nearest to the cable entry). Make sure that the locking nuts on the clamp are aligned with the
cable entries.
2 Attach the two locking nuts to the threads on the weather protection clamp. Tighten the lock-
ing nuts with a 10 mm socket wrench.
3 Lower the weather protection cover onto weather protection clamp until the hole for the lock
is in the slot at the front of the cover.
4 Put the R-clip into the hole at the front of the weather protection cover.
End of the procedure.
i
DR5200QS-LM, EDO#6-13-112 - Issue #3
www.drexelbrook.com
INSTALLATION
2
30
Advertisement
Table of Contents
