Remote Version - Ametek DR5200 Quick Start Manual

DR5200

3.1.2 Remote version

Terminals for electrical installation
Figure 3-5: Terminals for electrical installation
1 Grounding terminal in the housing (if the electrical cable is shielded)
2 Current output -
3 Current output +
4 Location of the external grounding terminal (on the wall support)
INFORMATION!
Electrical power to the output terminal energizes the device. The output terminal is also used for
HART ® communication.
Connections between the remote converter and the antenna housing
Figure 3-6: Connections between the remote converter and the antenna housing
1 Remote converter
2 Antenna housing
3 Power supply: voltage in -
4 Power supply: voltage in +
5 Signal cable B
6 Signal cable A
7 Shielding wire (attached to Faston connectors in the housings of the remote converter and the antenna housing)
For more electrical installation data, refer to
For more data about the signla cable between the remote converter and the antenna housing,
refer to the handbook.
DR5200QS-LM, EDO#6-13-112 - Issue #3
ELECTRICAL CONNECTIONS
Compact version
www.drexelbrook.com
on page 32.
3
34