Solar-Log 2000 Installation Manual page 80

Configuring connected devices
Reference voltage section
In addition to the current measured by the CT, a reference voltage is needed for the power output
calculation. This reference voltage can either be
•
recorded via the inverters and/or calculated by the Solar-Log™
•
or set in the box reference voltage [V].
If the Solar-Log™ does not receive voltage values from the inverters (for example during night), an
average value is calculated and used.
By activating the
input box is always used for the power output calculation.
Device Detection
During the
adjusted and named accordingly in the meter configuration menu under
Configuration.
80
Always use stored voltage
Note
process, the CT defined here is
button, the value entered in the reference voltage [V]
The reference voltage value is predefined by the
country settings. Please check this value.
It is best to measure the reference voltage and
enter this value.
recognized as a meter
and can be
Configuration | Devices |