Solar-Log 2000 Installation Manual page 100

Editing Data
Resetting inverter configuration section
If the Device Detection needs to be started again, it is recommended to delete the previous inverter
configuration with this function.
Procedure
•
Click on
•
If you are sure that the data should be deleted, click on Delete. Otherwise click on Cancel.
•
The data and inverter configuration are deleted.
•
The Solar-Log™ reboots itself
Resetting event log section
The event logs can be deleted with this function.
Procedure
•
Click on
•
If you are sure that the data should be deleted, click on Delete. Otherwise click on Cancel.
•
The event log is being deleted.
•
The Solar-Log™ reboots itself
Restore factory settings section
This function restores the Solar-Log™ to its factory settings. All of the yield data and configuration is
deleted.
Procedure
•
Click on
•
If you are sure that the data should be deleted, click on Delete. Otherwise click on Cancel.
•
The factory settings are being restored
•
The Solar-Log™ reboots itself
Note:
The network settings remain with the Solar-Log 1200 and 2000.
DHCP is enabled with the Solar-Log 300
100
RESET
RESET
RESET