Codes Indicated By As-I Gateway With Standard Function Range - Pepperl+Fuchs AS-I 3.0 PROFIBUS Manual

In stainless steel

Hide thumbs

Table Of Contents

Table of Contents

AS-i 3.0 PROFIBUS Gateway in Stainless Steel

Codes Indicated by the Display

Checksum error in the data menu.

"breakpoint":

Control III C program in break point.

Error while attempting to exit the configuration mode: A slave with address

zero exists.

General error while changing a slave address

The front panel operation is blocked. Until repowering-up the device can only

be accessed from the host via the interface.

Program reset of the AS-i Control program: The AS-i Control program is being

read from the EEPROM and copied into the RAM.

Display test while starting up the AS-i master

Error while changing a slave address in protected operating mode: No slave

with address 0 existing.

Error while changing slave address: Target address is already used.

Error while changing slave address: New address could not be set.

Error while changing slave address: New address could only be stored volatile

in the slave.

Error while changing the slave address in protected operating mode: Slave has

wrong configuration data.

The error 95 is caused by a superfluous slave and not by a missing slave. That

is why the slave address is occupied by this superfluous slave.

(In the protected mode the slave addresses which caused any configuration

error can be displayed by pressing the SET button. AS-i master without graph-

ical display are not able to differentiate between a missing slave, an incorrect

slave or a redundant slave. All incorrect addresses are displayed.

By pressing the SET button 5 sec. the displayed address starts to flash. Press-

ing the SET button again the master attempts to program the slave at the

address 0 to the incorrect address.)

13.1