Pepperl+Fuchs AS-I 3.0 PROFIBUS Manual page 89

In stainless steel
Table of Contents

Advertisement

AS-i 3.0 PROFIBUS Gateway in Stainless Steel
Glossary
ID2 Code, extended ID2 code
The ID2 code is set by the slave manufacturer and cannot be changed. The AS-i
Association determines the ID2 codes, which are assigned for a particular class of
slaves. For example, all 2-channel 16 bit input slaves having an S-7-3 bit code
use ID2 code "D". Since this code was not introduced until AS-i Specification 2.1,
it is also referred to as extended ID2 code.
Current configuration
The configuration data of all slaves detected by the master. The configuration
data of a slave, the ⇒ slave profile, consists of:
⇒ IO code, ⇒ ID code, ⇒ extended ID1code , ⇒ extended ID2 code.
Current parameter
The AS-i parameter that have most recently been sent to the AS-i slave, as op-
posed to ⇒ permanent parameters.
Configuration Error/Config Error
An configuration error is displayed if the target and the current configuration of the
connected slaves do not match. A configuration error could be due to the follow-
ing:
Missing slave:A slave entered in the ⇒ LPS is not available
Wrong type of slave:The ⇒ slave profile of the connected slave does not comply
with the configuration.
Unknown slave: A connected slave is not entered in the ⇒ LPS.
LAS - List of Activated Slaves
The master exchanges I/O data with the slaves entered in the LAS. In protected
mode only the detected slaves (
entered in the
the
LDS are activated.
LDS - List of Detected Slaves
If the master was able to read the
LPF - List of Peripheral Faults
The list of peripheral faults was introduced with specification 2.1. This list includes
an entry for each slave that signals a
LPS - List of Projected Slaves
The list of projected slaves includes all slaves expected by the master. When sav-
ing the current configuration all entries in the
cept for a slave with address 0).
LDS) that are expected by the master and are
LPS are activated. In configuration mode all slaves entered in
slave profile, the slave is entered in the LDS.
peripheral fault.
LDS are stored in the LPS (ex-
89

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents