Diagnostics Interface; Vbg-Pb-K20-D-Ev1, Vbg-Pb-K20-Dmd-Ev1, Vbg-Pb-K20-D-Ev; Chip Card; Using The Chip Card - Pepperl+Fuchs AS-I 3.0 PROFIBUS Manual

AS-i 3.0 PROFIBUS Gateway in Stainless Steel
Electrical connection
7.6

Diagnostics interface

The service and diagnostics interface (in conjunction with AS-i Control Tools
software) is used for communication between the PC and the unit.
7.6.1

VBG-PB-K20-D-EV1, VBG-PB-K20-DMD-EV1, VBG-PB-K20-D-EV

The service and diagnostics interface in these devices is as RJ45 female config-
ured and it is placed on the front plate, on the left hand side.
7.7

Chip card

The configuration is stored in a fixed installed EEPROM and can be overwritten
by the chip card. The chip card does not have to be inserted in operation.
Warning!
Power must always be turned off when removing or inserting the chip card!
7.7.1

Using the chip card

The chip card integrated in the AS-i master is used to read-out and to store con-
figuration data.
7.7.1.1

Card unformatted

If an unformatted card is found when the device is started, the following is dis-
played:
The chip card is formatted and then the data copied to the chip card.
28
NEW CHIPCARD
WILL BE FORMATED
AS-I DATA WILL
BE SYNCHRONIZED