Geberit Chicago Faucets Commander Manual page 6

Section 1: Introduction, Device, Updates
1.4 Updating Your Device
Your new Commander should
normally come with the latest
software and firmware installed. Refer to
the update section of www.chicagofau-
cets.com/commander page to review
the version information.
To check if your device has the latest
version, from Main Menu tap "ABOUT".
Look for Version information. If your
version is a lower number, you will need
an update.
Chicago Faucets Commander Handheld Programming Unit User Guide
® ™
REGISTER your device at chicagofaucets.com/commander to access software,
firmware and hardware updates. Supply an e-mail to receive notification for
future updates.
chicagofaucets.com/commander
In order to update the Commander Handheld Unit, download and
installation of Renesas Flash Development Toolkit (FDT), Evaluation version (free)*,
is required:
http://am.renesas.com/products/tools/flash_prom_programming/fdt/downloads.jsp
*Requires PC running Windows 7, 10, XP, and Vista
UPDATE STEPS
1. Download update files
1.1 Download zip package from www.chicagofaucets.com/commander
Note: Zip package includes these files:
• Readme file Readme.txt
• Firmware update file Verxx.xx.xx.fpf4
• Graphics software update file Resource.bin
1.2 Unzip files onto your PC
2. Flash programming update
Be sure the Commander device is off and PC audio is not muted!
2.1 Connect device to PC via USB cable (supplied)
Note:
• If this is the first time the device is connected to a particular PC, you may
see a note from Windows saying that it has found new hardware or new
USB device is being installed
• If Windows "alert" tone sounds, device is in "programming mode". Go to
Step 2.4.
2.2 Quick click "on/off button" to activate "Programming mode"
2.3 If PC fails to recognize device, or no audio tone is heard:
• Unplug and reconnect Commander device, begin step 2 again OR
• Tap Commander Unit Reset, and begin step 2 again
Page 6 CF2026 / 07/19