Geberit Chicago Faucets Commander Manual page 26

SECTION 2: Scanning, Mode and Setting Adjustments
2.6.3 Reset
Reset allows the user to view existing fitting settings relative to the factory
setting. This is important if the fitting is not operating correctly, or there is a need
to cancel the current Settings. There are two options available: Factory (Default)
or Current (as of last SET command)
Factory — Shows what the factory settings
are for the scanned fitting. FAC Initiates
Reset of fitting to match Factory Setting
Current — Lists current settings for the
fitting, including any settings that may have
been modified after the fitting was installed.
CUR — Initiates Reset of fitting to match
Current Settings
FAC — Initiates Reset of fitting to match
Factory Setting
Warning: Some data loss may occur when using RESET -
(example, but not limited to number of uses, uses per day).
This occurs because scan data is not written to the module
immediately. The information buffers for a certain time, and
is written to the module at some later date. Any scanned
information in the buffer will be lost by using RESET.
Chicago Faucets Commander Handheld Programming Unit User Guide
® ™
To execute command:
Tap "FAC" for reset to factory setting
OR
Tap "CUR" for reset to current settings
Reset caution appears. Tap "SET" to continue or
"CANCEL" to end command with savings
Page 26 CF2026 / 07/19