Geberit Chicago Faucets Commander Manual page 18

SECTION 2: Scanning, Mode and Setting Adjustments
2.6.1.2 Running Mode
Metering — Fitting will operate only when user is detected and stops after a prescribed amount of time.
This helps to promote water conservation and prevent long run ons of the fitting.
Metering Running Time
Choose "Factory" pre-set for 10
second running time.
Choose "Custom Setting" and
adjust running time from 3 to 180
seconds with slide bar.
—
Set Tap "SET" to save and
execute settings.
Chicago Faucets Commander Handheld Programming Unit User Guide
® ™
—
Min Interval Between Uses
Choose "Factory" pre-set for 2
second delay time before new
detections are registered.
Choose "Custom Setting" and
adjust delay time from 1 to 5
seconds with slide bar.
Page 18
—
CF2026 / 07/19