Nortel 1120E Administration Manual page 76

76 Upgrade and convert the IP Phone 1120E firmware
6
7
Follow the next procedure to convert the UNIStim Firmware to SIP Firmware
on the IP Phone 1120E.
Procedure 12
Converting UNIStim Firmware to SIP Firmware using TFTP
Step
1
2
Table 14
Sample 1120e.cfg configuration file
[FW]
DOWNLOAD_MODE AUTO
VERSION 06C25D26.bin
FILENAME 1120e.img
3
4
Copyright © 2008, Nortel Networks
.
From the Search Results, select the appropriate version of the SIP
Firmware for the IP Phone 1120E, for example, IP Phone 1120E
Release 0625C1HD26.bin.
Place the selected firmware on the provisioning server.
Action
Run the TFTP server (for example Tftpd32.exe).
Place firmware and configuration files in the folder of the TFTP
server (for example 1120e.img F/W file and 1120e.cfg file) that
contains the following lines:
Configure the IP Phone 1120E Device Settings TFTP IP address to
the IP address where your TFTP server is running.
After you are finished the configuration, the IP Phone reboots and
sends a request to the TFTP server.
Select the Apply&Reset Context-sensitive soft key to save the
settings and reset the IP Phone 1120E.
The following messages display on the IP Phone 1120E as the IP
Phone 1120E cycles through the conversion process, one after the
other:
1. [FW] Reading...
2. [FW] Writing...
3. [FW] Finished...
SIP Firmware Release 1.1 for IP Phone 1120E Administration
NN43112-300 02.03 Standard
—End—
27 May 2008