Nortel 1120E Administration Manual page 45

Tone configuration commands
•
•
•
Copyright © 2008, Nortel Networks
.
Create the Device Configuration file on the provisioning server 45
is -1, the 802.1P value is retrieved from the Service Package. The
default value is 6.
— x - a value from -1 to 7 indicating the 802.1P value.
DIAL_TONE [frequency1 | frequency2 | on_time | off_time] is used to
select the tone advising the caller that the exchange is ready to receive
call information and invites the user to start sending call information.
You can select the country specific tone. The default tone is the North
American tone.
— frequency1 - the frequency of tone 1.
— frequency2 - the frequency of tone 2.
— on_time - the duration of the tone when it is on. A -1 indicates
a continuous tone.
— off_time - is the duration when no tone is played.
The following are examples of DIAL_TONE:
1. 350,440;-1 (350 and 440 Hz continuous tone)
RINGING_TONE [frequency1 | frequency2 | on_time | off_time] is
used to select the tone advising the caller that a connection is made
and a calling signal is applied to a telephone number or service point.
You can select the country specific tone. The default tone is the North
American tone.
— frequency1 - the frequency of tone 1.
— frequency2 - the frequency of tone 2.
— on_time - the duration of the tone when it is on. A -1 indicates
a continuous tone.
— off_time - is the duration when no tone is played.
The following are examples of RINGING_TONE:
1. 440,480; 2000,4000 (440 and 480 Hz with 2 seconds on, 4 seconds
off)
BUSY_TONE [frequency1 | frequency2 | on_time | off_time] is used
to select the tone advising the caller that the telephone number is busy.
You can select the country specific tone. The default tone is the North
American tone.
— frequency1 - the frequency of tone 1.
— frequency2 - the frequency of tone 2.
SIP Firmware Release 1.1 for IP Phone 1120E Administration
NN43112-300 02.03 Standard
27 May 2008