Stun_Server_Ip1; Stun_Server_Port1; Stun_Server_Port2 - Nortel 1120E Administration Manual

•
•
•
•
•
•
VQMon configuration commands
•
Copyright © 2008, Nortel Networks
.
Create the Device Configuration file on the provisioning server 47
NAT_MEDIA [NONE | STUN] indicates the type of protocol used for
NAT traversal in the media ports. The default is NONE.
— NONE - is the default and disables NAT_MEDIA.
— STUN - the most common NAT traversal protocol for the media (RTP
and Real-time Control Protocol [RTCP]) port.
NAT_TTL[x] is used to set the NAT Time-to-live (TTL), the binding
lifetime in seconds. This command causes the IP Phone 1120E to ping
the ports at regular intervals shorter than the TTL to prevent the NAT
from tearing down the ports. The default is 2 minutes (120 seconds).
— x - is the binding lifetime in seconds.
STUN_SERVER_IP1[ip_address] NAT traversal using STUN protocol
requires a STUN server in the public internet. Two STUN server IPs
can be provisioned.
— ip_address - the IP address of STUN server 1.
STUN_SERVER IP2[ip_address] NAT traversal using STUN protocol
requires a STUN server in the public internet. Two STUN servers IPs
can be provisioned.
— ip_address - the IP address of STUN server 2.
STUN_SERVER_PORT1[port_number] is the port number used
corresponding to STUN_SERVER_IP1. The default port number is
3478.
— port_number - is the port number.
STUN_SERVER_PORT2[port_number] is the port number used
corresponding to STUN_SERVER_IP2. The default port number is
3478.
— port_number - is the port number.
VQMON_PUBLISH [YES | NO] is the command that is used to enable
or disable the publish message containing the voice quality monitoring
metrics sent to the Proactive Voice Quality Monitoring (PVQMoN)
collecting server.
— YES - enables VQMoN.
— NO - disables VQMoN. NO is the default.
SIP Firmware Release 1.1 for IP Phone 1120E Administration
NN43112-300 02.03 Standard
27 May 2008