Configure The Device Settings - Nortel 1120E Administration Manual

STUN S1 IP
Enter an IP address for the STUN S1 IP device. The STUN server must
reside in the public Internet for STUN protocol to be effective.
STUN S2 IP
Enter an IP address for the STUN S2 IP device. The STUN server must
reside in the public Internet for STUN protocol to be effective.
Configure the device settings
This section describes how to provision the Device Settings parameters
regardless of DHCP mode (Full DHCP, Partial DHCP, or No DHCP).
Parameters that are not needed in Full or Partial DHCP mode are grayed
out on the IP Phone 1140E screen and cannot be modified.
Follow the next procedure to provision the Device Settings parameters on
the IP Phone 1140E with SIP Firmware.
Procedure 13
Provisioning the Device Settings parameters
Step
1
2
Table 21
Using the Navigation key cluster to navigate in the Network menu
Key
Down
Up
Right
Left
Select key (center of cluster)
Copyright © 2008, Nortel Networks
.
Action
Press the Globe/Services key on the IP Phone 1140E quickly twice.
The Network menu appears:
Table 20
Network menu
1. Server Settings
2. Device Settings
3. Diagnostics
4. Lock
To navigate in the Network menu, use the Navigation key cluster:
SIP Firmware Release 1.1 for IP Phone 1120E Administration
NN43112-300 02.03 Standard
Action
Moves highlight down
Moves highlight up
Selected current menu item
Closes menu
Selects current menu item
27 May 2008
Configure the device settings 89