Device Settings On The Ip Phone 1120E With Sip Firmware; Introduction - Nortel 1120E Administration Manual

Device Settings on the IP Phone 1120E
with SIP Firmware
An IP Phone 1120E with SIP Firmware displays different menus than the menus
displayed on an IP Phone 1120E with UNIStim Firmware.

Introduction

This chapter details how to configure the Device Settings parameters on
the IP Phone 1120E with SIP Firmware. This includes items such as the
IP address, the subnet mask, and the gateway IP address of the IP Phone
1120E.
The Device Settings parameters are listed in the following table in the
order they appear on the Device Settings menu of the IP Phone 1120E
with SIP Firmware. Read the section at the end of this chapter that explains
how to provision the Device Settings parameters. If you are familiar with
the Device Settings parameters, skip the last section in the chapter and
proceed to the provisioning instructions.
Table 15
Parameters in Device Settings menu
Enable 802.1x (EAP)
Device ID
Password
DHCP
SET IP
Net Mask
Gateway
DNS IP
Voice VLAN
VLAN Filter
Copyright © 2008, Nortel Networks
.
SIP Firmware Release 1.1 for IP Phone 1120E Administration
NN43112-300 02.03 Standard
ATTENTION
27 May 2008
81