Commissioning; Technical Data; Contact Allocation Table - Festo EduTrainer Manual

5 19-inch module 16DOUT

5.2 Commissioning

1. Connect the inputs/outputs to the PLC using a flat cable:
– SV3/SV4: Siemens S7 (16-pin)
– SV1/SV2: Other controller types (10-pin)
2. If using modules in parallel, these can be connected via the free insulation-displacement connector
SV1/SV2 or SV3/SV4 using flat cables.
3. Connect the 24 V power supply by means of the 3-pin connector SL1 or SL2.
4. Use the jumper JP1 or JP2 to define whether the output module is supplied directly via 24 V or via
24 V NA. 24 V NA is switched off in the event of an EMERGENCY-STOP
(jumper between pins 1 and 2: supply via 24 V; jumper between pins 2 and 3: supply via 24 V NA).
5. Screw the 19-inch module into the frame.

5.3 Technical data

Operating voltage
Output current
Connection
Front-plate width
Subject to change

5.4 Contact allocation table

Pin SV1
1 L1+
2 Q0
3 Q1
4 Q2
5 Q3
6 Q4
7 Q5
8 Q6
54
SV2 SV3 SV4
L2+ 0V 0V
Q0 Q7 Q7
Q1 0V 0V
Q2 Q6 Q6
Q3 0V 0V
Q4 Q4 Q4
Q5 0V 0V
Q6 Q4 Q4
24 V DC
Max. 0.5 A per output
4 mm safety sockets
12 modules
Pin SV1 SV2
9 Q7 Q7
10 0V 0V
11 — —
12 — —
13 — —
14 — —
15 — —
16 — —
© Festo Didactic GmbH & Co. KG 739319
SV3 SV4
L1+ L2+
Q3 Q3
L1+ L2+
Q2 Q2
L1+ L2+
Q1 Q1
L1+ L2+
Q0 Q0